Rives Dot has an understated geometric texture of fine dots, inspired by contemporary sportswear and the concrete of the urban landscape. Ukuran 32 x 46 cm Isi Per pack 100 lembar Gramature: 250 gram Design and pre-press · A screen of 133 -150 lpi should be used. · Finer screens up to a maximum of 200 lpi can also give very good results with careful ink density control. · For dark 4 colour images with high ink density, under colour removal may be required depending on the visuals. · Aim for the total ink film weight of 260%. Offset litho printing For optimum results on textured products increase the blanket pressure or use a softer blanket to achieve consistent ink lay down. Printing inks · Conventional positive drying inks should be used with or without infra-red drying assistance. · Fully oxidizing inks or UV inks may also be used. · Avoid using overnight / stay fresh / duct stable inks (this is essential for Ice White, where fully-oxidizing inks are recommended). · Always allow sufficient drying time. · Use laser stable inks for subsequent laser printing. · It is always advisable to consult your ink supplier about specific projects to ensure ink suitability. Paper handling · To help avoid marking and set-off when printing multiple colours, 35micron anti set off spray for boards and 20micron for paper weights are recommended. · It may also be helpful to turn off the delivery stack joggers and restrict the delivery pile height particularly when printing boards. · Always protect paper from environmental humidity and temperature changes by using stack covers or stretch wrap. Sealers and coatings · Sealers and press coatings can be used to help reduce marking for further operations. · Ensure suitable inks are used prior to varnishing and that the inks are completely dry before varnish application. · Not recommended for paper weights. Consider a clear hot foil as an alternative. Silk screen printing #digitalpaper #fancydigital